Tag Archives: Reclaimed wood

Vanity featured image

Reclaimed Vanity From rough boards – How It’s Built

This is a vanity that I built for a previous home of mine in Southeast Portland. All of the wood came from the Rebuilding Center. They were very rough boards to start with but once milled down they produced a nice finished product.01 reclaimed wood rough boards Reclaimed Vanity From rough boards   How Its BuiltIn this image you can see the boards I was working with on saw horses behind my house, plus the van that I used to move to portland.

02 reclamed wood riped down Reclaimed Vanity From rough boards   How Its BuiltThe thickness of the boards that I was working with ranged from 1 1/4 inches to 5/8 of on inch. The easiest way to create a uniform slab thickness was to cut the boards to a consistent width of 1 1/2 inches and turn them on edge. I then planed the broad surfaces of the boards to prepare them for edge gluing.

03 edge gluing with pony clamps Reclaimed Vanity From rough boards   How Its BuiltThe pieces each get a light coat of glue. I usually use a paint brush to apply it and then get clamped together.

04 edge glueing with pony clamps Reclaimed Vanity From rough boards   How Its BuiltHere are more pieces of wood being glued. The clamps I use are Pony pipe Clamps and they screw onto 3/4 inch gas pipe so you can make clamps whatever length you want.

05 edge glued wood Reclaimed Vanity From rough boards   How Its BuiltHere are the two pieces that will be joined to form the bottom of the vanity. I have a 13 inch planer so I glued the pieces up in two sections that would fit through my planer. Once the pieces had gone through the planer I then glued those pieces together and used a belt sander followed by an orbital sander to smooth the joint.


07 edge glued wood Reclaimed Vanity From rough boards   How Its BuiltHere’s the full width bottom piece and one of the vertical pieces. 

08 reclamed vnity top Reclaimed Vanity From rough boards   How Its BuiltThis is the vanity top after unclamping and before sanding.
09 routing dado on vanity top Reclaimed Vanity From rough boards   How Its BuiltI made a jig from some scrap plywood in the garage to rout out channels to fit the vertical pieces.

10 asembing the vanity Reclaimed Vanity From rough boards   How Its BuiltHere is the vanity being assembled. 

11 reclamed vanity installed Reclaimed Vanity From rough boards   How Its Built

After a whole lot of cutting, gluing, clapping and sanding here is the finished and installed vanity. All of the wood for the vanity it’s self is reclaimed fir and the doors are made out of painted scrap plywood.